A peer's endpoint may be a link-local IPv6 address with the interface it
is on. Such a peer is the address and the interface together, wherever
peers are told apart: admission, collisions, hold-downs, the refusal log,
the status page. The interface is looked up by name each time it is
needed, so one that appears later or is made anew is found.
Our routes go out with our link-local address in both places of
MP_REACH_NLRI's next hop, as FRR sends its own. A peer's link-local next
hop is taken alone, twice, or after "::" (BIRD), and resolved in the
kernel on the interface of the session rather than by looking fe80::/64
up, which every interface has.
The lab has a new phase, linklocal: sessions with FRR (by interface, with
radvd beside the daemon) and BIRD over a LAN with link-local addresses
only, both families, pings across, the interface down and up.
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
For a link that has only IPv6 addresses.
- The Extended Next Hop capability is offered on every session over IPv6
whose families include IPv4 unicast, and used if the peer offers it too.
Nothing to configure.
- On such a session our IPv4 routes go out in MP_REACH_NLRI with the
session's IPv6 address as next hop, and are withdrawn in
MP_UNREACH_NLRI. Without the agreement they are not sent, as before.
- IPv4 routes are read with an IPv6 next hop, global or global with
link-local.
- The kernel installer resolves an IPv4 route's IPv6 next hop like any
other and installs it: by way of an IPv6 nexthop object, or with RTA_VIA
where routes carry their own gateway.
Tested against a real kernel in both modes, with a link-local next hop
too, and in the lab against FRR and BIRD: the new `v6only` phase takes
the IPv4 addresses off the exchange LAN, runs one IPv6 session with each
router for both families, and pings IPv4 across.
Sessions between link-local addresses are not supported yet.
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
scripts/interop/lab.sh runs the daemon against FRR, BIRD and Routinator,
each in a network namespace on one exchange LAN, and checks what every
side ends up with: sessions and routes over IPv4 and IPv6 with their
attributes, four-octet AS numbers, ADD-PATH, RFC 9234 roles and Only to
Customer, RTR version 2 and invalid routes, route refresh, session resets,
killed peers, a cut wire, the daemon stopped and killed, a table of a
million routes and a restart under it, role mismatch and the prefix limit.
All of it passes against FRR 10.5.1, BIRD 2.18 and Routinator 0.15.2.
scripts/interop/real-rpki.sh checks the RTR client against a Routinator
with the real RPKI: 713,258 IPv4 and 187,479 IPv6 VRPs and 3,379 ASPAs,
the same numbers on both sides.
What the lab found, fixed here:
- A daemon restarted with its routes in the kernel removed them all at
once, its table being empty until the peers had sent theirs again, and
then put them back: no forwarding meanwhile. Routes of an earlier run
are now kept for `stale_seconds` (120 by default) and only those nobody
announced again are removed. A restart under a million routes takes
1.1 s to be in step, with nothing removed.
- FRR ends a session it loses to a collision with a state machine error
without a subcode, which was shown as "error code 5 subcode 0".
CI gets a job that runs the lab.
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
